Re: Repairing the imported data gives me headache :(
I looked at the file and tried some quick things on it. I would say you can remodel it from scratch faster then repairing it. Someone beat it with the fillet bat and that's where a bulk the errors are.
View ArticleRe: How can I distance a circle from the surface I am putting it on?
I tend to prefer revolve over extrude for cylindircal profiles other than a straight cylinder.
View ArticleRe: Prime Problems: Document Interaction
I'm interested in PTC and user advice more recently - say, since Prime 2. Have there been any usability labs in that time? Has anyone in this forum been able to communicate bug reports, problems or...
View ArticleClik here to view.
How to solve this PDE ?
Does the information given by the system mean that mathcad cannot handle this kind of parabolic equation?
View ArticleClik here to view.
Re: Modelling a suction cup
Steve,Is this what you are after? The offset of DTM1 controls the 'squash' of the cup shown below as a section.Model attached.
View ArticleRe: How can I distance a circle from the surface I am putting it on?
I tried using these in my copy of Creo Parametric 2.0, but due to a glitch, this glitch http://communities.ptc.com/thread/56970 So I need to get that fixed first, because these were created in a...
View ArticleRe: Modelling a suction cup
Even a one-piece item has complex internal stresses and deflections that are not accurately represented by a geometry solution, particularly if the supporting surface for applying loads to the suction...
View ArticleRe: How can I distance a circle from the surface I am putting it on?
I think you will find what you wanted orginally in the Blend feature. This allows you to define offsets between sketches. You can use taper in extrude but it only takes angle references. You would...
View ArticleRe: User need help with Simulation setup.
Hi DenisThe Aluminum part (first part in assembly - as shown in model tree) = millimeters Kilograms Second (mmKs)The Polypropylene part (second part in assembly - as shown in model tree) = millimeters...
View ArticleLicense is lost error message after renewing yearly license
I am getting a "licence is lost" error message even after renewing my yearly license. How do I get rid of this message so I can save files?
View ArticleRe: License is lost error message after renewing yearly license
Welcome to the forum, Jack. Did you replace your license file? Is this an academic version or something? I'm going to suggest you have a problem reading the correct MAC address.
View ArticleRe: License is lost error message after renewing yearly license
Thank you for the responce. We replaced our license file by using the Re-Licensing guide from PTC. It is CREO 2.0 Student Edition. We are an FTC team trying to save file on a Windows 8 machine.
View ArticleRe: License is lost error message after renewing yearly license
Is this on the same machine as it was running before? Technically this is the recommended route by requesting a support case... Lower left of the...
View ArticleRe: PTC should make Creo existing functionality more stronger
As one partner, I think, to balance of competition, PTC has to development some new extensions to comparing other 3-rd CADs so that sales can meet some specific business requirement for new customer...
View ArticleRe: User need help with Simulation setup.
David, If you're on maintenance with PTC, then I would upgrade to Creo Simulate 3.0, which has LDA (large deformation analysis) with contact.
View ArticleRe: Enhancements to Revise Part and CAD Documents - 1. Revise Part Only
Jennifer,This is quite a complex posting. After reading through, I like where it is going. Your proposal is if a certain version of a CAD file is associated to multiple versions of WTPart, then only...
View Article