Re: Pro/Sheetmetal Bend Question

Hi, All.

I'm using Creo Wildfire 5

I've had much the same problem as was described in this post. Mine is a sheetmetal blend created between two sketches. I can't even create edge bends, which leads me to believe I did something very wrong. The steps I took are as follows:

Insert

Unattached

  Blend

Then, once in the blend options:

General

Select Sketch

  Straight

   Chain Selection of two curves (my two sketches)

    Material Direction Out

Attached is a picture of the part.Image may be NSFW.
Clik here to view.

Image may be NSFW.
Clik here to view.

Thanks, Jonathon Kilihoffer